Wire Harness Inspection Products
Surface treatment of terminal cross section
Requesting Main Industry : Manufacture of automotive harnesses
A non-harmful liquid is needed when performing surface treatment when preparing cross-sectional samples
Problems we had
Since deleterious substances (nitric acid aqueous solution) are used in the surface treatment at the time of preparing the cross-sectional sample, it is desired to switch to a safe and harmless liquid agent because it is dangerous.
Solving Problems
The electrolytic etching system uses a dedicated harmless etching solution (which can also be exported overseas) and applies voltages harmless to the human body to the terminal surface so that each core wire can be observed cleanly.
Introduced equipment
Other examples of introduction
Industry : Manufacture of automotive harnesses
The Cross-Sectional Sample Preparation Efficiency of Crimping Terminals should and the Crimping Quality should be improved
Cross-sectional evaluation of ...
Industry : Manufacture of automotive harnesses
Measuring the dimensions of the wire peeling length before crimping is needed
There is a special terminal wh...
Industry : Manufacture of automotive harnesses
A crimp terminal rupture tester that can be pulled at a constant speed is needed
In the manual tensile testing ...
Industry : Production of consumer harnesses
Voluntary inspections by facility operators should be eliminated to save manpower
The self-inspection of workers...
Industry : Manufacture of automotive harnesses
I want to detect a defective crimp that could not be found by visual inspection
Visual inspection results in h...
